Best Possible Pellet Mill Plant

Attentions to Use Ring Die Pellet Mill Machine

pellet mill machine

Ring die pellet mill machine has the good economic and social benefits as they can save energy and reduce emissions, but there are also some aspects need to be attention when using the ring die pellet mill machine.

1. Before raw material entering the pellet mill machine, in order to prevent the loss of the pressure roller and ring mold of pellet mill machine, any metal is forbidden to mix into the raw material.

2.The powder raw material before entering into the pellet mill machine should be processed in approximately 15-20% moisture content, too high impact molding, too low will create high temperature and then cause blockages.

3. Before the ring die pellet mill machine turning on, you must check whether the oil road is normal, in case of high temperature burning out the bearings part.

4. When you start pellet mill machine, feeding rate can not too be fast, it needs around 10min for body heating process, after 10 min, you can adjust to be normal speed, the jam will not happen.

5. If you change new ring die mould of pellet mill machine, you must go through an abrasive grinding process, the specific method is: 1: 2: 7 with oil, sand and saw dust. Operating from artificial feeding into the mouth repeatedly, it takes about 40 minutes.

6. According to the material conditions and temperature changes, you can adjust the feeding speed of screw feeder of pellet mill machine.

7. At the beginning of the feeding process for pellet mill machine, generally powder is more and forming particles less, this is normal phenomenon, it can be normal after a few minutes.

8. Always check all parts of the bolts, nuts, fasten pipes to prevent loosening.

Prev:
Next:

Leave a Reply